Sold out
DREMEL® Workstation (220)
This combined Drill Press and Tool Holder is the perfect solution for stationary working with your Dremel. Drill vertically or in an angle, adjustable in increments of 15 degrees. Holds tool horizontally for polishing and sanding. Integrated, telescoping tool stand holds tool with Flex Shaft (225). On-board accessory storage. Cord management keeps cord safely stowed. Depth markings for consistent depth adjustment. Base markings (metric and inches).
Additional information
| Brand | Dremel |
|---|---|
| Material | Steel |
Reviews (0)
You must be logged in to post a review.
Related products
Sanding Sponge 80G
- Small, flexible sponge for general purpose sanding of a variety of materials
- Hand fit size
- Coated 4 sides
Kreg Jig® HD Driver Bit
- 6" (152mm) driver with deep #3 square drive
- Optimized for use with Kreg Jig® HD Screws
- Solid, one-piece construction
- Quick-Change compatibility
- Magnetic ti
GRR-RIPPER Advanced 3D Pushblock
GRR-RIPPER Advanced 3D Pushblock comes with 3 legs featuring proprietary Green GRR-RIP® non-slip material, built-in balance support, adjustable handle, and includes two additional accessories: Stabilizing Plate, Adjustable Spacer.
Stabilizing Plate locks the material against the fence keeping your work square and flush. It provides 250% more stabilizing surface to keep your work under control when resawing on the table saw or routing on the router table.
Adjustable Spacer give you 54% more gripping surface and 1" of additional cut capacity to take on your biggest projects and wider cuts.
Material Support Stop
- For use with Kreg Jig® K3, K4, and K4MS (not compatible with K5)
- Supports workpiece at same height as Kreg Jig® base
- Can be positioned any distance from your Kreg Jig®
- Lets you repeat the same pocket hole over and over again
- Stop swings out of the way to serve as a support for large panels
Brass brush 13 mm (536)
Brass brushes are non-sparking and softer than steel. They will not scratch soft metals like gold, copper, brass.
- Ideal for cleaning and surface-finishing items
- For use on items made from gold, bronze, copper or brass
- Use a brass brush to create a soft, satin or matte finish
- Very effective on flat surfaces and in hard-to-reach areas like slots
Kreg Jig® HD (Heavy-Duty) Drill Bit
- For use with the Kreg Jig® HD manual pocket-hole jig
- Compatible with Kreg Quick-Change Chuck and standard chucks
- Drills 1/2" (12mm) diameter pocket holes
- One-piece, hardened-steel design
Deflector / Connector for GRR-RIPPER and GRR-RIP BLOCK
Deflector/Connector also serves as a bridge between two GRR-RIP BLOCK or GRR-RIPPER Pushblocks. It allows for multiple configurations when used on the table saw, router table, and shaper. Connect two GRR-RIP BLOCKs for handling larger material like raise panel door fronts while you pattern route. Or connect two GRR-RIPPER in tandem for ripping longer stock.
Kreg Jig® Mini
- Simplistic, compact design
- Unlimited material thickness and width positioning
- Hardened-steel drill guide with lifetime warranty
- Wood-chip relief hole for easy drilling
- Glass-reinforced nylon body
- Guide to help fully seat plugs
Reviews
There are no reviews yet.